Know HowJointing

Know How · Techniques

Jointing and cutting a chicken with shears

Poultry shears are at their best cutting through a cooked carcass: here is how to take the legs off a roast chicken, divide them at the knee, cut the carcass into two bone-in halves and take off the wings. For neat breast slices, a carving knife is still the better choice.

Before you start

Use a rested, cooked chicken. Remove the trussing, use a stable chopping board and keep the bird supported. The aim is four leg pieces, two bone-in breast halves and two wings. Cutting through the breastbone and ribs is the job shears do best; it is different from slicing boneless breast meat. Choosing and holding the shears is covered on Poultry shears.

A sharp knife does the joint jobs (legs, knees and wings) easily too: open up the gap in the joint and cut the tissue holding it together. [1, 2] For neat breast slices, lift the breast off the ribs with a knife and slice it on the board, as in How to carve a chicken. Shears come into their own when you are portioning through the carcass, rather than carving slices for presentation.

Step by step

Step 1Remove the leg quarters

Draw a leg gently away from the breast and cut the skin between them. Open the hip joint and cut through the connecting tissue to free the thigh and drumstick together. Do the same on the other side. [1]

One hand pulls a roast chicken leg away from the body while kitchen scissors cut through the skin and tissue at the hip joint.
Illustration

Step 2Separate the thigh and drumstick

Bend each leg to find the knee joint. Cut through the gap in the joint and its connective tissue, keeping the cut between the bones. [1]

A roast chicken leg quarter on a board, with kitchen scissors cutting through the knee joint between the thigh and the drumstick.
Illustration

Step 3Cut the carcass into halves

With the legs off, open the shears and slide the lower blade in from the cavity end, beneath the breastbone, with the upper blade above it. Keep your supporting hand to one side of the cutting line. Cut along the centre of the breastbone with short, controlled closes of the shears, opening the carcass as you go. The shears must cut through the bone and cartilage, not just snip the breast skin. Stop and reposition if they slip or need a lot of force. [1]

The back still joins the two sides. Cut through the ribs alongside the backbone on each side to free the bone-in breast halves; keep the backbone for stock. Check the cut edges and remove any loose bits of bone before serving. [1]

A hand steadies a roast chicken on a wooden board while the other hand cuts along the centre of the breastbone with black-handled poultry shears.
Illustration

Step 4Remove the wings

Once each breast half is free, pull its wing gently outwards to open up the shoulder joint, then cut the connecting tissue through the gap in the joint. A sharp knife can make the same cut. [1, 2]

Keep your supporting hand away from the blades. If the cut meets hard resistance, open the shears again and find the joint, rather than forcing the blades through the bone next to it.

A hand pulls the whole wing outwards from a roast chicken breast half while kitchen scissors cut through the shoulder joint.
Illustration
Sources for this guide (2)
  1. Reem Tiltman – How to Carve a Whole Roast Chicken with Kitchen Scissors
  2. Daniel Gritzer – How to Carve a Roast Chicken (Serious Eats)

Written 17 November 2026. Sources checked on 17 November 2026.

See also